The unique vertical operation float switch ensures that the pumps operate within their footprint, removing the possibility of the float snagging during operation and allowing the pumps to be used within smaller sumps. The vertical float switch is also very flexible, allowing the pump switching height to be adjusted between the ‘on’ and ‘off’ positions, as well as the height relative to the pump.
Newton CP Pumps hold a 1-year back to base manufacturers’ warranty. If installed and maintained by a Newton approved installer, the back to base warranty increases to 3 years.
3-year warranty (refer to datasheet)
Thermal overload protection against mortar burnout
Non-clogging vortex impeller
Protection against motor burnout due to locked impeller
Double mechanical seals ensure increased durability against particle abrasion and wear
Anti-airlock impellor housing ensures that the pump is able to remove trapped air even when sump was previously dry
High performance with low current and high efficiency
Unique vertical float allows complete adjustment of start and stop height
Continued pumping even during power cut when used with Newton Power Converters
Primarily designed to be used with Newton sump systems for the removal of ground water collected by Newton System 500 basement waterproofing system, Newton CP pumps can also be used for the removal of water from:
Flooded basements and cellars
Surface drainage collection vessels
Reservoirs and water holding vessels
Newton CP Pumps are supplied with a 1-year manufacturers warranty or a 3-year back-to-base warranty if the pumps are serviced by a Newton approved service engineer.
For any further information about the range of Newton CP250, CP400 and CP750 clean water pumps please ring 01732 360095 or e-mail firstname.lastname@example.org